Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | |||
|
select_table_filename [2015/10/13 18:39] admin |
select_table_filename [2026/08/28 03:33] (current) hermann Sync from local documentation review |
||
|---|---|---|---|
| Line 1: | Line 1: | ||
| - | ====== Select Table Filename ====== | + | ====== Select Table Filename ====== |
| ===== Description ===== | ===== Description ===== | ||
| - | This container picks up a file name from a series of file names. | + | Container that picks one table filename out of a series connected inside it, based on the current step. Each candidate filename must be connected through a [[Number Table Filename]] hook, whose number identifies the step at which that filename takes over. A filename begins being selected once the model step reaches its number, and remains selected until the step reaches the number of another connected filename, allowing one table file to be swapped for another during a model's execution. |
| ===== Inputs ===== | ===== Inputs ===== | ||
| Line 12: | Line 12: | ||
| ^ Name ^ Type ^ Description ^ Default Value ^ | ^ Name ^ Type ^ Description ^ Default Value ^ | ||
| - | | Step | [[Positive Integer Value Type]] | Current step or model iteration. | 1 | | + | | Step | [[Positive Integer Value Type]] | Step used to pick the filename, automatically bound to the innermost compatible container. | 1 | |
| ===== Outputs ===== | ===== Outputs ===== | ||
| ^ Name ^ Type ^ Description ^ | ^ Name ^ Type ^ Description ^ | ||
| - | | Table Filename | [[Table Filename Type]] | A table filename. | | + | | Table Filename | [[Table Filename Type]] | Selected table filename. | |
| ===== Group ===== | ===== Group ===== | ||
| Line 23: | Line 23: | ||
| [[Functor List#Stack | Stack]] | [[Functor List#Stack | Stack]] | ||
| - | ===== Notes ===== | + | ===== Notes ===== |
| - | This container allows the replacement of one table file name with another during a model execution. Any table file name inside this container will begin to be used by a simulation according to its number identifier and will continue to be used until the model step reaches the number identifier of another table file name inside the same container. | + | Only [[Number Table Filename]] hooks can be connected inside this container. |
| - | Each table filename inside the Select Table Filename must be provided by a corresponding [[Number Table Filename]]. | + | The selected filename is the one with the greatest number identifier that is still less than or equal to Step. |
| - | ===== Internal Name ===== | + | ===== Internal Name ===== |
| SelectTableFilename | SelectTableFilename | ||